NewPro NC Flex SG 70 gives sand-blasted or etched glass surfaces a permanent anti-fingerprint finish
NewPro NC Flex SG70 gives sand-blasted or etched glass surfaces a permanent anti-fingerprint finish. Thanks to optimum filling of the structure, grease and dirt becomes invisible and can be easily removed.
There is barely any visible shading of the protected glass. Privacy protection through opaqueness is not impaired.
Once fully cured NewPro NC Flex SG70 is resistant to conventional solvent-based glass cleaners.
Through the intelligent arrangement of hybrid (organic and inorganic) structures, NewPro NC Flex SG70 constitutes concept.
Specifications
Chemical basis: modified silicon dioxide
Layer thickness: > 5000 nm
Water resistance: no
Oil resistance: no
Slip angle: not applicable
Temperature stability: 100°C permanent
Chemical stability: between pH 3 and pH 09
Weather resistance: 3500 h pursuant to ISO 11507 A
Durability (mechanical): > 5,000 cycles pursuant to ISO 11998
Salt-water resistant: yes
Transparency: 100%
Storage stability: 2 years
Temperature sensitivity: 2°C to 30°C
Consumption: 15 ml/m2
Application:
drops of the liquid are applied either on a slightly absorbent cloth or directly to the substrate. Disperse across the surface with light polishing motions. Visible streaks can be removed immediately through gentle polishing motions. The coating is waterproof and fully cured after 24 hours.
NewPro NC Flex SG70 is not available in any other versions. The product is solvent-based - spray application is not recommended. The product is non-hazardous according to ADR and IATA. This complex technology cannot be diluted.
Please observe the relevant safety data sheet when using NewPro NC Flex SG70